| 1 |
Test Operation |
| 1.1 |
Turn on Workbench using the Control Panel. |
| 1.2 |
Ensure that movement is smooth in all both directions. |
| 1.3 |
Turn off Workbench using the Control Panel. |
| 2 |
Remove Left Guard. |
| 2.1 |
Remove Bolts. |
| 2.2 |
Detach Left Guard. |
| 3 |
Remove Drive Pulley. |
| 3.1 |
Remove Belt from Pulleys. |
| 3.2 |
Remove Key and Slave Pulley from Clutch Shaft. |
| 3.3 |
Remove Key and Drive Pulley from Drive Motor Shaft. |
| 3.4 |
Remove Pully Cover. |
| 3.5 |
Remove Guard Bracket and Sheetmetal Screws. |
| 4 |
Remove Main Drive Motor. |
| 4.1 |
Disconnect Power Cord from Main Drive Motor. |
| 4.2 |
Losen the Bolts, preventing movement during operation. |
| 4.3 |
Losen the Bolts, using a Wrench. |
| 4.4 |
Remove Bolts, Washers and Nuts. |
| 4.5 |
Remove Main Drive Motor. |
| 5 |
Remove Clutch Drive Assy and Bolts. |
| 6 |
Remove Power Cord |
| 6.1 |
Remove the Sheetmetal Screws. |
| 6.2 |
Remove Power Cord and Cable Clamps from Motor Mounting Plate. |
| 7 |
Remove Motor Mounting Plate. |
| 7.1 |
Detach Motor Mounting Plate from Workbench. |
| 7.2 |
Remove Bolts and Washers from Motor Mounting Plate. |